Hi,
I'd like to start feeding to FR24. I have a SDR-RTL USB Dongle connected to my computer and using RTL1090 I see that I receive ADS-B messages.
I've downloaded the Windows feeder software but only get Connection terminated messages as shown in this picture:
FR24.png
As far as I can see there are two options:
I can use the FR24 software directly or I can go via RTL1090. Is this correct?
What settings should I use in either case?
Trying without the RTL1090 I enter:
- My email address
- Sharing key
- DVBT Stick
- Step 4.3 - Enter your additional dump1090 arguments or leave empty - I have no idea so I leave empty
- Step 5.1 - Would you like to enable RAW data feed on port 30002 (yes/no)$: - I have no idea; so yes
- Step 5.2 - Would you like to enable Basestation data feed on port 30003 (yes/no) - I have no idea so no (since I do not have Basestation as far as I know)
- Step 6A - Please select desired logfile mode: Again no idea so I choose disabled
What am I doing wrong here?
Thank you.
I'd like to start feeding to FR24. I have a SDR-RTL USB Dongle connected to my computer and using RTL1090 I see that I receive ADS-B messages.
I've downloaded the Windows feeder software but only get Connection terminated messages as shown in this picture:
FR24.png
As far as I can see there are two options:
I can use the FR24 software directly or I can go via RTL1090. Is this correct?
What settings should I use in either case?
Trying without the RTL1090 I enter:
- My email address
- Sharing key
- DVBT Stick
- Step 4.3 - Enter your additional dump1090 arguments or leave empty - I have no idea so I leave empty
- Step 5.1 - Would you like to enable RAW data feed on port 30002 (yes/no)$: - I have no idea; so yes
- Step 5.2 - Would you like to enable Basestation data feed on port 30003 (yes/no) - I have no idea so no (since I do not have Basestation as far as I know)
- Step 6A - Please select desired logfile mode: Again no idea so I choose disabled
What am I doing wrong here?
Thank you.